FiberSystem

BY
Metrohm Process Analytics
Metrohm Process Analytics
Description

The NIRS Analyzer Pro is a single point process analysis system based on high resolution diode array technology. It provides non-destructive analysis of liquids, granules, powders, slurries or opalescent substances by using fiber optics microbundles and contact probes for reflectance and transflectance measurements.

Key Differences
Technical Specification

NIRS Analyzer Pro
Analysis time: 5 - 50 ms / integration time; average time per result: 1 - 15 seconds.
Wavelength range: 1100 - 1650 nm
Detector: InGaAs diode spectrum
Spectral dispersion: 1.1 nm / pixel

General
Lifetime of the light source: Dual lamp system MTBF = 17,500 h
Software package (sold separately): Vision for instrument operation and method development
Wavelength accuracy: 0.5 nm
Wavelength precision: < 0.02 nm
Wavelength stability: < 0.01 nm/°C
Noise: < 60 Micro-AU
Random vibrations: 0.4 Grms at 10 - 150 Hz in accordance with IEC 60068-2-64 / 0.4 Grms at 10 - 1250 Hz in accordance with international Metrohm standard (additional information available on request)
Temperature: -5 - 40 °C (23 - 104 °F). With purge -5 - 65 °C (23 - 149 °F).
Purge: Flow rate min. 5 l/min, > 99.99% anhydrous, > 99.9% without oil and fine particles up to 0.3 μm
Humidity: 10 - 90% relative
Dimensions: (W × H × D) 42 × 42 × 13.5 cm (16.5 × 16.5 × 5.3 inches) + holders for the device
Weight: 25 kg / 55 lbs
Cabinet: 1.5 mm (lid 2.5 mm) stainless steel EN 1.4301 (SS2333)
Protection: IP69K 1) in accordance with IEC 60529 and DIN 40050 Part 9, NT ELEC 023
Power supply: disconnected from network or network-dependent (recommended) / 100 - 240 VAC, 50 - 60 Hz, 2.0 A, 150 W
1) IP6x is the highest protection against dust entering the device. IPx9K means protected against the effect of high-pressure water and/or steam cleaning at high temperature.

Downloads
FiberSystem
Related Products